A unique water-based Nanotechnology Penetrating Sealer engineered for the protection of all porous, honed and polished surfaces with an Eco-Friendly composition.
MG Nano Sealer penetrates underneath the surfaces protecting it from the inside. It’s not a coating and will not change the natural aspect, no film is created over the substrate keeping it breathable to allow for water vapors to escape the substrate and providing a crack and scratch free protection.
Perfect to protect against pollution, most stains and mild acids. Additionally, gives UV protection retarding aging of treated surfaces.
Perfect do Seal and Protect
- Quarry Tile
- Ceramic Tile
- All kind of Porous Surfaces
- VOC Compliant
- Solvent Free
- Low Odor
- 90% Bio Degradable
- Ready and Easy-to-use
- Interior and Exterior
- Superior Stain Protection
- High Yield
- No Yellowing
- Smoke and Fumes Free
Nano-structured additives in water based solution.
Up to 900 square feet per gallon
HOW TO USE
Shake well before using.
Always make a test in a small area.
1 The surfaces must be neutralized *, clean, dry and free from dust, for better surface neutralization use products from Bio Easy Clean and Degreaser Bio Cleaner Nano4you lines.
2 Use the product in its pure state (without additives, nor solvents), impregnate the surface to saturation, do not over saturate the surface with the product, on the vertical surfaces always apply from the bottom up.
3 Apply one coat of the product to the surface with the help of a brush or roller, the product should be applied until the surface is completely wet.
4 Allow the product to penetrate and dry (10 to 60 minutes according to the porosity and temperature of the material),remove excess without abrasion, with a clean, soft cloth before full drying.
5 The surface may be polished with a wool beret and without abrasives after application of the treatment.
6 The surface will be dry in 1 hour and protected after 24 hours. Maximum efficiency achieved after 48 hours.
7 Clean application tools with Bio Easy Clean product.
Avoid corrosive substances like muriatic acid or chlorine during pre-cleaning.
The protection can last up 2 years if the cleaning and manutainance is done with proper products. Corrosive alkaline acids will damage the protection and the surface.
Valid for 24 months from date of manufacture.
Do not ingest or inhale this product.
Avoid contact with skin or eye area.
If product does come into contact with skin or eyes, immediately flush affected area with area
With water for at 15 minutes. In case of ingestion, contact Poison Control immediately at (800) 222-1222.
Do not reuse empty bottle